The Regent Dinbloc is the close coupled motorpump version of the Dinflow centrifugal pump.

The Dinbloc uses standard Dinflow pump components, and specially designed support frame and stub shaft to couple the pump directly to a foot-and-flange, metric frame electric motor.


Casings and Impellers in combinations of cast iron, bronze, zinc-free bronze and stainless steel
Stainless steel shafts – varying grades for specific liquids
TEFC motor is standard; others such as flameproof and immersion-resistant may be fitted

Close coupled design eliminates coupling mis-aligment problems, and has a cost saving advantage over traditional long coupled units
Designed and built to DIN Standard 24255
Standard metric motors used; replacements easily available world-wide
Mechanical seals are fitted, and are available with a variety of elastomers and face materials to suit a wide range of fluids and temperatures
Volute casing with replaceable wear ring
Back pull-out design for ease of maintenance
Maximum operating pressure 1,600 kPa
Flows to 300 L/S
Heads to 150 metres
Suits both 50 and 60 Hz electric motor speeds

General Transfer
Air Conditioning
Cooling Towers
Marine ( sea water )
Chilled Water
Process Industry
Water Treatment and Supply
Food and Drink Manufacture
General Industry

The following chart will help you with your choice of a Regent pump; for assistance, click on the chart to generate an email (that you can edit) addressed to Regent pumps’ Sales department.


Click here to create an email that you can edit before sending.
Click here to create an email that you can edit before sending.